Engine Oil

Replacing oil in the engine car is straightforward, although there may be some difficulties and therefore should adhere to certain rules in carrying out this work. Before changing the oil in engine it is desirable to use washing the engine. Autochemicals offers a great range of facilities for washing motor internals. Should choose those that are cast into the engine for a few minutes to replace oil, the so-called minute. One should note the following things: If your engine uses hydraulic lifters valve clearances, and the insides of the engine are not very clean, it is better refrain from the use of drilling fluids, for the reason that soluble washing fluid deposits can get into the inner cavity of lifters and disable him. In this case, better use the detergent properties of the oil, and make the next oil change at an earlier date.

(usually the extent of pollution of oil.) Once the motor is going to play with washing fluid set time should be stop the engine and by removing the drain plug to drain the old oil, it is not necessary to unscrew the filler cap, the inner cavities of the engine enough seats communications with the atmosphere. Once the butter is completely drain from the crankcase (normally it takes about 10 – 15 minutes.) should tighten the drain plug in place. After this untwists oily filter, applying for this special device, if not, then untwists by hand, pre-wrapped body of carnival filter coarse sandpaper. If this method does not work, try to break his body a suitable screwdriver, and unscrew it with unyielding filter. Before installing a new carnival filter should grease his rubber gasket, and in the cavity is not superfluous to pour a little oil, which in future will be used in the engine. Especially hard on tightening the carnival filter should not be. Usually, after the rubber seal touches the cylinder should dovernut its still about 1 / 3 turn. Following this with a funnel pour oil in the engine, but not all, as suggested by user maintenance of the car, and about 2 / 3 of its parts, usually for four cylinder engines is approximately three liters of oil.

Tighten the filler plug and start up the engine. Once the oil pump motor oil fetch all the channels the engine light will go out the emergency oil pressure. Usually it will take a little more time than normal engine start. Give engine for several minutes and stop it. Add oil to the engine to the mark 'MAX'. Browse again if there were any drips of oil (oil filter, drain plug.) In this procedure the oil change may be considered complete

Tags:

Comments are closed.