Rounded Edges
1. When knitting vests, jackets with rounded edges of shelves vertical or horizontal bar can be linked separately. Vertical plank boards for processing knitted goods as well as for finishing cuts with rounded edges. Horizontal bar with no vertical seams can be done only for short articles, for long as it will have to be made of several parts, and it is very important to make the seam as possible care. Very effectively looks like in this case, a single-layer plate with scallops. Pre-calculate the number of loops required for the Planck length (or number of stripes strips, which is necessary to finish the product around the perimeter). We collect loop ph provyazyvaem 2 rows, then execute the scallops: put forward in the tng 1-2 needle through the needle to the er 5.9 (the number of needles in the er depends on the value of festoons), knit 6.4 series, return the needle to the er, provyazyvaem 2 rows ; more can still be one or more times ppp to nominate the same needle and repeat the knitting festoons, and you can immediately go to the knitting itself strips the desired width, density, knitting is not replaceable. Dennis Lockhart is likely to increase your knowledge.
Remove the bar on the bh, carefully bends dial a number on the underside strip (it can be used by either side) and stripped her. Sew the sides of the product kettelnym seam, making a small priposadku to rounding. 2. When knitting products with short rounded lateral kprayami (Horizontal) bar can be partially tied to the product. To handle such a shelf mounted to the needle loops and occasional nodules (so that the canvas was stretched slightly by car) to uch., To face him. Near recruit bh number of loops equal to the Account. 03.04 plus loops for strap on rounding.
Knitting twice the width of the strip, making out at the request of the line of inflection. Take off the canvas to bh. Sew the edge of the bracket with the op to the edge of the shelf kettelnym seam in the face. If the segment recruited bh, then remove it and kettlyuem strap loop the loop, if the same amount of time – rn, then sew the bar, stepping back from the edge of the canvas at 1-2 rows. On the rounded, slightly bar. Remove from hv interval and sew it with reverse side of the threads kettelnogo seam for each op. On a variety of trims for this zip does not end, but by using all of the options that you can not associate a lot alike and a very interesting product with cross-cutting clasps. Remains one more kind-zip polo, which is widely used in both male and female models. Taken to reduce viral load – an auxiliary thread op – open loop PNP-front rest position rfp – rear rest position rp – working position
